Installing A Hard Drive/Ssd Blank; Shutdown Procedure For Servicing A Hard Drive/Ssd; Configuring The Boot Drive - Dell PowerEdge FC830 Owner's Manual

Figure 29. Removing and installing a 1.8 inch SSD blank
1. SSD blank
Next steps
1. Install the hard drive/SSD. See

Installing a hard drive/SSD blank

Prerequisites
1. Ensure that you read the
2. Remove a hard drive/SSD. See
Steps
Insert the hard drive/SSD blank into the hard drive/SSD slot until the release latch clicks into place.

Shutdown procedure for servicing a hard drive/SSD

NOTE: This section applies only to situations where the sled must be powered down to service a
hard drive/SSD.
If you need to service a hard drive/SSD, turn off the sled and before removing the hard drive/SSD wait for
30 seconds after the sled indicator turns off. Otherwise, the hard drive/SSD may not be recognized after it
is reinstalled and the sled is powered on again.

Configuring the boot drive

The drive or device from which the system boots is determined by the boot order specified in the System
Setup.
82
Installing a hard drive/SSD.
Safety instructions.
Removing a hard
2. release latch
drive/SSD.