Table of Contents
Advertisement
1.8.6. SCREEN MODE
Used to set the screen mode when a signal with other than 4:3 aspect ratio, as HDTV or SXGA
signal, is input. If it has the 4:3 aspect ratio, the displaying doesn't change.
•
NORMAL: The original aspect ratio is maintained and the whole image is displayed at the
center of the screen. The margins are displayed black.
•
TRIMMING: The original aspect ratio is maintained and the center of the image is enlarged
filling the entire screen. When an HDTV image with 16:9 aspect ratio is displayed, the right
and left edges of the image are cut. When an SXGA image with 5:4 aspect ratio is displayed,
the top and the bottom of the image are cut.
•
FULL: The aspect ratio is adjusted o fill the whole image in the entire screen. The image with
16:9 aspect ratio appears stretching vertically. The image with 5:4 aspect ratio appears
stretching horizontally.
[Procedure]
1.
Select SCREEN MODE in DISPLAY in the menu 2.
2.
Select the screen mode option.
Note: Even if the effective image area is 16:9, when ASPECT-RATIO (chapter 1.7.5.5, on page
44) is set 4:3, the SCREEN MODE doesn't change the display since the image is processed as
4:3.
1.8.7. Display memory saving
The adjusted values can be saved in the display memory. The number of memories is 256.
Note: The registered input memory is required when you save the display memory. If the input
memory has not been registered, register it before the display memory registration.
[Procedure]
1.
Press [ESC] button during the menu 2 displaying to show "SAVE THE CHANGES?"
message. And select YES in reply to it. To exit the menu without saving, select NO or press
[ESC].
2.
Designate the memory number by left/right buttons and press [ENTER] button to save.
3.
The current setting will be saved in the memory if the number is unregistered. If it has
already been registered, the overwrite confirmation message will be displayed.
4.
If you don't save it, press [ESC] button to exit the menu.
1.8.8. Display memory calling/deleting
Registered display memory can be called and deleted when needed.
•
Call: Press [MEM LIST] button and select DISPLAY MEMORY. Designate the memory
number to call by left/right buttons and press [ENTER] button. It can be called directly when
3-digit number is input by number buttons in remote control. If you call the display memory 1,
press 001.
•
Delete: Press [MEM LIST] button and select DISPLAY MEMORY. Designate the memory
number to delete by left/right buttons and press [ENTER] button. Select DELETE MEMORY
by up/down buttons and press [ENTER] button.
49
REV 1.4
Advertisement
Table of Contents
