Table of Contents
Advertisement
1.2.6.3. Fixing to the wall and floor
You don't have to attach the lower door in this chapter since the picture outline has yet to be
adjusted as explained in the next chapter.
After the picture outline adjustment, attach the door in the reverse order of 1.2.6.1.
1.
Attach floor fixing brackets to 4 corners of the level adjuster and fix them to the floor with the
anchor bolts.
2.
Fix the back of the upper part of the projector to the wall with wall fixing brackets such as
shown in the following figure.
Caution
Make sure the whole set is assembled firmly and installed stably. To prevent the set
from falling due to unpredictable events such as earthquakes and shocks, fix the set
firmly to the wall and floor. Furthermore, carefully confirm the strength of the fixing area
of the installation place (wall and floor). The wall and floor fixing method differs
according to the number of the assembled units.
Hexagon socket head
cap screw (M6)
Adjuster
11
Wall fixing brackets
Anchor bolt
Anchor bolt
Floor fixing brackets
REV 1.4
Advertisement
Table of Contents
