Table of Contents
Advertisement
1.7. Input memory setting (When the input board is selected)
1.7.1. Selecting input port
Input port can be selected while any menus or test patterns are
not displayed.
[Procedure]
1. Press [INPUT A] button to display input port selecting
menu.
2. Select the input port by up/down buttons and press
[ENTER] button. Then input port changes.
To exit the menu, press [ESC] button.
The current selected input port can be checked in any other
adjustment menu in advanced mode.
Note:
•
When the input board, VC-B20KA is attached, S.ANALOG and S.DIGITAL can be selected.
•
When the input board, VC-B20KV is attached, COMPOSITE and Y/C can be selected.
1.7.2. Expansion setting
It is necessary to set the horizontal and vertical expansion
rate at 100 % before adjusting the input signal, since you
need to verify the adjustment result by displaying the
effective input signal area on the screen.
[Procedure]
1.
Select DISPLAY in the menu 2.
2.
Select H.DISPLAY POS. and change it to 1/1 by
left/right button.
3.
Select V.DISPLAY POS. and change it to 1/1 by left/right
button.
Note: If H.SIZE or V.SIZE (chapter 1.7.4.2, on page 40) in the menu 1 (page 1) is changed,
H.DISPLAY POS and V.DISPLAY POS should be readjusted to 1/1.
1.7.3. Automatic input signal scanning
[NORMAL] button executes automatic input signal scanning during the menu 1 displaying.
The automatic scanning can search and display the signal that accords with the sync signal
frequency in the default memory (preset supported signals) and already registered input
memories. If more than one signal has the same frequency, the selected signal will be switched
every time [NORMAL] button is pressed. Also in the case that incorrect image is displayed, press
[NORMAL] button again to reselect other candidates.
If the signal does not match, the following items in the menu 1 have to be adjusted.
VS-50XL20U, VS-67XL20U, VS-50XLW20U
Set-up and Installation Manual
INPUT PORT
ANALOG
DIGITAL
S.ANALOG
S.DIGITAL
COMPOSITE
Y/C
S.ANALOG
DISPLAY MEMORY UNDEFINE
INPUT MEMORY
H.DISPLAY POS
V.DISPLAY POS
CROP
DISPLAY
OUTPUT
SCREEN MODE
38
Input port selecting menu
ID01
1
1/1
1/1
DISABLE
NORMAL
DISPLAY menu
Advertisement
Table of Contents
