Setting up your projector (continued)
Correcting skewed or distorted image
For the best projection, project images on a ﬂ at screen
installed at 90 degrees to the ﬂ oor. If necessary, tilt the
projector using the two adjustment feet on the bottom
of the projector.
1. Tilt up the projector to the appropriate angle.
2. Rotate the adjustment feet for ﬁ ne adjustment.
• Don't transport the projector with its adjustment
feet extended. Otherwise the adjustment feet may
When ﬁ ne streaks are seen on
This is due to interference with the screen surface and
is not a malfunction. Replace the screen or displace
the focus a little. (See page 12 for focus adjustment.)
When the projected image is
When the projected image is distorted, carry out any
of the KEYSTONE, CORNERSTONE, and CURVED-
mode adjustments to correct the distortion.
When the image distorts in a trapezoid shape, use the
KEYSTONE-mode adjustment. For ﬁ ne adjustment
of the image shape, use the CORNERSTONE-mode
adjustment. To adjust the image projected on a curved
surface, use the CURVED-mode adjustment.
When you press the ENTER/GEOMETRY button on
the projector or the GEOMETRY button on the remote
control, the menu switches in the order of KEYSTONE,
CORNERSTONE, CURVED, regular display, KEYSTONE...
Adjustment using the KEYSTONE mode:
When the screen and the projector are not placed
perpendicularly to each other, projected images
become trapezoidal. If you cannot place them
perpendicularly to each other, press the ENTER/
GEOMETRY button on the projector or the
GEOMETRY button on the remote control to display
the KEYSTONE mode and then press the , , or
button to correct the distortion.
Every time you press the BLANK button, the
adjustment menu changes as follows:
KEYSTONE RESET KEYSTONE ...
You can correct the distortion vertically or horizontally
focusing on the screen center.
In the following cases (for front projection):
When you press the or button in the RESET
mode, the distortion correction is reset.
• For proper KEYSTONE-mode adjustment results,
reset the lens to the factory-adjusted position using
LENS SHIFT RESET in the INSTALLATION 1 menu
before carrying out KEYSTONE-mode adjustment.
(See page 34.)
• When the KEYSTONE-mode adjustment is carried
out, the adjustment value is indicated. Note that
this value doesn't mean a projection angle.
• When the KEYSTONE-mode adjustment takes
effect, the resolution decreases. In addition, stripes
may appear or straight lines may bend in images
with complicated patterns. They are not due to
SELECT : BLANK