How To Remove The Drain Cock (Primary Circuit); How To Remove The Flexible Hose - Mitsubishi Electric EHSC-VM2B Service Manual

DISASSEMBLY PROCEDURE

12. How to remove the drain cock (primary circuit)

(1) Remove the front panel. (Refer to Procedure 1.)
(2) Swing the control box to the front. (Refer to Procedure 4.)
(3) Remove the drain cock (primary circuit).

13. How to remove the flexible hose

(1) Remove the front panel. (Refer to Procedure 1.)
(2) Swing the control box to the front. (Refer to Procedure 4.)
(3) Cut the band. (Photo 13-1, 13-2)
(4) Cut the pipe cover tape about 10 cm from the top and
peel off the pipe cover.
(Photo 13-1)
* Reattach the pipe cover after reconnecting the flexible
hose.
(5) Loosen the flexible hose nuts on both ends and remove
the flexible hose. (Photos 13-1, 13-2)
* When reinstalling the nuts, use new G1" gaskets.
Photo 13-2
Nut
(G1")
Band
Flexible hose
OCH532A
Gasket (G1")
Gasket
(G1")
Nut
(G1")
PHOTOS
Photo 12-1
Nut (G1")
Flexible hose
Photo 13-1
Tape Nut (G1")
Plate heat exchanger
Refrigerant piping
78
Booster heater
Drain cock
Gasket (G1")
Flexible hose
Band