Line Out Connections - Sanyo FXD-770GD Operating Instructions Manual

Notes
• When using a two-speaker installation, the Green, Green/Black, Violet, Violet/
Black wires, which are used for a four-speaker installation, are not used. The
ends of these wires must be covered with electrical tape to prevent them from
shorting to the unit or the vehicle chassis.
• When using a two-speaker installation, set the FADER control to the center po-
sition.
REPLACING THE FUSE
When fuse replacement is necessary remove the blown fuse
by using pliers. Then install the new 10 amp. fuse.

LINE OUT CONNECTIONS

• The unit has a line out terminals. You can use a separate rear channel amplifier to upgrade your system.
RCA Line- out Jacks (For Rear Speakers)
• Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA
line output jacks to the line input terminals of the external amplifier.
GB
E
F
D
FXD-770GD_Ebody(P01-18)
RCA Line-out Jacks
White (Left)
Red (Right)
18
18
External Amplifier
Rear Speaker
3/7/01, 5:57 PM