3
Dimensional drawing & centre of gravity
3 - 1 Dimensional drawing
FTXG25,35E
The mark (Y) shows piping direction
Rear
Left
Reduction gear unit fixed screws (inside panel)
Bottom
Front grille fixing screws
(Inside)
Operation lamp
Name plate
Signal transmitter
Infrared remote control
(ARC433A41)
• Indoor Units • R-410A • FTXG-EV1BW_FTXG-EV1BS
Rear
Right
(198)
Operating
state
Signal receiver
Timer lamp
Intelligent eye lamp
Intelligent eye sensor
Room temp. thermistor (inner)
Earth terminal
(M4 Inside panel)
Indoor unit ON/OFF switch
Blade angle
Up/down (automatic)
Dry
Cooling
Heating
Right/Left
(Automatic)
• Split Sky Air • Indoor Units
Required space for
installation
Air flow (indoor)
(Space for
Including mounting plate
operation)
Room temperature thermistor (bottom view)
Terminal block with
earth terminal
Gas pipe 9.5Cut (The length of
pipe outside the unit: about 340)
(Inside)
Up and down wind
direction control blade
Liquid pipe 6.4CuT (The length of pipe
movable range
outside the unit: about 390).
Wall hole for embedded piping
J65 hole.
Standard locations of wall holes
unit (mm)
(Space for operation)
Drain hose (connecting part I.D.
J 14.0, O.D. J 18.0)
(The hose length on the
outside of the unit is
approx. 440)
Wall hole J65 hole
3D050494
3
3
5