Dell PowerEdge 1900 Systems Owner's Manual page 17

Table 1-4. LCD Status Messages (continued)
Code Text
E1211 ROMB Batt
E12nn XX PwrGd
E1229 CPU # VCORE
E122B 0.9V Over
Voltage
E122C CPU Power Fault
E1310 RPM Fan ##
E1410 CPU # IERR
Causes
RAID battery is either missing,
bad, or unable to recharge due to
thermal issues.
Specified voltage regulator has
failed.
Processor # VCORE voltage
regulator has failed.
0.9 V regulator voltage has
exceeded the allowable voltage
range
A voltage regulator failure was
detected when the processor
regulator(s) was enabled
RPM of specified cooling fan is
out of acceptable operating range.
Specified microprocessor is
reporting a system error.
Corrective Actions
Reseat the RAID battery. See
"Replacing the SAS RAID
Controller Daughter Card
Battery" on page 95, and
"Troubleshooting System Cooling
Problems" on page 115.
See "Getting Help" on page 137.
See "Getting Help" on page 137.
See "Getting Help" on page 137.
See "Getting Help" on page 137.
See "Troubleshooting System
Cooling Problems" on page 115.
See your system's Information
Update Tech Sheet located on
support.dell.com for the most
current system information. If the
problem persists, see "Getting
Help" on page 137.
About Your System
17