Osd; Check Points Before Operation - Digital Watchdog PTZ39XFM User Manual

3

OSD -

Check Points Before Operation

Check Points Before Operation
1. Before power is applied, please check the cables carefully.
2. The camera ID of the controller must be identical to that of the camera you wish to control. Check the camera ID in
"System Information" of the OSD menu.
3. If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.
4. If you changed camera protocol by changing DIP switch, the change will be effective after you reboot the camera.
5. Since the operation method can be different for each controller available, refer to the manual for your controller if camera
cannot be controlled properly.
1
Preset and Pattern Function Pre-Check
Check how to operate preset, pattern, scan, and group
functions with the keyboard controller or DVR in advance
to operate the camera functions using those devices.
(Refer to your DVR or system keyboard manual.)
2
Auto Calibration
If the camera is continuously subjected to very high
temperatures (over 50°C or 122°F) for a long period, the
camera can lose focus and produce blurry images.
In this case, it is recommended to turn on
AUTO CALIBRATION.
If you execute AUTO CALIBRATION, camera will calibrate its
focus every six hours.
3
Open OSD Menu
Preset, pattern, scan, group, and alarm input function call all
be configured for your camera using the OSD menu.
Enter "Preset Key + 0" or "Pattern + 30. "