Genesis GTS10SB Operator's Manual page 7

• Always secure the work piece against rip fence or miter gauge.
• Always use push stick for ripping narrow stock
close to the saw blade
• Never cut freehand,
piece. Always use rip fence or miter gauge to position and guide the work
• Stand to the side of the blade and work piece.
of your body in line with the path of the saw blade.
• Never reach behind blade when the saw blade is rotating.
• Move rip fence out of the way when cross cutting.
cut off gauge when cross cutting
• Keep saw blade clean and sharp.
binding in the work piece.
• Feed the work piece through AGAINST the rotation of the blade.
Feeding material from the back of the saw invites an accident and can cause serious injury.
Use support for the sides and back of the saw table when cutting
•
wide or long work piece.
• Never cut more than one work piece at a time.
or bind and lead to unexpected contact with blade.
• Keep rip fence parallel to the saw blade to avoid binding or
kickbacks.
• Never pull the work piece through the spinning blade.
kickback and cause serious personal injury. You can be dragged into the blades during a
kickback.
• Do not rip a work piece that is twisted or warped or does not have a
straight edge to guide along the fence.
• Never make through cuts narrower than ½".
effective for narrow rip cuts and will not prevent kickback.
• Never attempt to free a stalled saw blade without turning off the
saw and unplugging the saw from the power source.
• Avoid cutting nails or other metal pieces.
the work piece.
• Always turn the saw off before unplugging the saw from the power
source
to avoid accidental starting when re-plugging into to the power source. Never leave
the table saw unattended while connected to a power source.
• Use only accessories rated for the speed recommended on the tool
warning label or higher.
rated at least 4,800 rpm or higher with 5/8" arbor. Accessories running at speeds greater than
rated can fly apart and cause personal injury.
• Save these instructions.
.
Use a push block or feather board for non-through cuts
which means using only your hands to support or guide the work
The blade for this table saw must be 10" (254mm) in diameter,
Refer to them frequently and use to instruct other users.
so your hand does not come
NEVER stand or hand any part
A Dull and sticky blade will increase the risk of
Stacked work pieces can shift
The blade guard system is not
Inspect for and remove all nails from
NEVER use rip fence as a
It may cause
7