Genesis GTS10SB Operator's Manual page 6

Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in
Canada) to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Amperes
(At Full Load)
0–2.0
2.1–3.4
3.5–5.0
5.1–7.0
7.1–12.0
12.1–16.0
16.1–20.0
SPECIFIC SAFETY RULES FOR TABLE SAWS
WARNING:
(GAINED FROM REPEATED USE) REPLACE STRICT ADHERENCE TO
PRODUCT SAFETY RULES. If you use this tool unsafely or incorrectly, you can
suffer serious personal injury!
Do not cut metals with the table saw.
•
plastic materials. However, some wood and plastic materials are quite hard and slippery. The anti-
kickback pawls may not stop kick back. Do not stand, or let anyone stand in line with potential
kickback.
• To avoid tipping your table saw in operation, firmly BOLT it to a work
stand or bench.
• Unplug saw from power source before making adjustments, repairs,
maintenance or storing.
• Do not turn on the table saw before clearing the table of all tools,
wood scraps,
• Wear eye and hearing protection.
unless otherwise specified, everyday glasses provide only limited impact resistance, they are not
safety glasses, use only approved certified safety equipment; eye protection should comply with
ANSI z87.1 standards, protective hearing equipment should comply with ANSI s3.19 standards.
• Protect your lungs. Wear face or dust mask.
risk of personal injury.
• Tie back long hair and roll long sleeves above the elbow.
loose fitting gloves, loose clothing, jewelry and other items which can be caught in rotating parts
and cause serious personal injury.
• Always use blade guard, splitter and anti-kickback pawls on all
through cutting operations.
kickback and keep your hands away from the spinning blade.
6
Extension Cord Length
25 Feet 50 Feet
18 18
18 18
18 18
18 16
18 14
14 12
12 10
DO NOT LET COMFORT OR FAMILIARITY WITH PRODUCT
Long work pieces need extra support on the out-feed side.
etc, except the work piece and related feed or supporting devices
10" Table Saw
Operator's Manual
75 Feet 100 Feet
18 18
18 16
16 14
14 12
12 10
10 10
8 8
Table saws are designed to cut wood-like or
Accidental start up can cause serious personal injury.
Always use safety glasses with side shields,
The guard system is designed to reduce the intensity of
150 Feet 200 Feet
16 16
14 14
12 12
12 10
8 8
8 6
6 6
Following this rule will reduce the
Do NOT wear
GTS10SB