Consulting Programmed Actions; Tips And Tricks - Daikin EWAQ016BAW Installation And Operation Manual

Programming quiet mode
Programming quiet mode is carried out as follows:
INFORMATION
Returning to previous steps in the programming procedure
without saving modified settings is done by pressing the
button.
1 Press the button to enter the programming/consulting mode.
2 Select the operation mode you would like to program by means
of the and buttons.
The actual mode is blinking.
3 Press the button to confirm the selected mode.
4 Consult the actions by means of the
5 Hold down the button for 5 seconds to the program the
detailed actions
The first programmed action appears.
6 Use the button to select the action number you would like to
program or to modify.
7 Use the and
8 Use the button to select or deselect
9 Repeat steps 6 to 8 to program the other actions of the selected
mode.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
10 Press the button for 5 seconds to store the programmed
actions.
If the button is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored but 4 is deleted.
By pressing the button several times, you return to previous
steps in this procedure and finally return to normal operation.
11 You automatically return to step 5, start again to program the
following day.
EWAQ016~064BAW + EWYQ016~064BAW
Packaged air-cooled water chiller
4PW70082-1C – 2013.07
and buttons.
buttons to set the correct action time.
as action.
5.9.3.

Consulting programmed actions

Consulting space heating actions
Consulting space cooling heating, space heating or quiet mode is
carried out as follows.
INFORMATION
Returning to previous steps in this procedure is done by
pressing the button.
1 Press the button to enter the programming/consulting mode.
2 Select the operation mode you would like to consult by means of
the and buttons.
The actual mode is blinking.
3 Press the button to confirm the selected mode.
The actual day is blinking.
4 Select the day you would like to consult by means of the
and buttons.
The selected day is blinking.
5 Press the button to confirm the selected day.
The first programmed action of the selected day appears.
6 Use the and
programmed actions of that day.
This is called the readout mode. Empty program actions (e.g. 4)
is not displayed.
By pressing the button several times, you return to previous
steps in this procedure and finally return to normal operation.
5.9.4.

Tips and tricks

Programming the next day(s)
After confirming the programmed actions of a specific day (i.e. after
pressing the button for 5 seconds), press the
can now select another day by using the
and restart consulting and programming.
Copying programmed actions to next day
In space heating program it is possible to copy all programmed
actions of a specific day to the next day (e.g. copy all programmed
actions from " " to " ").
To copy programmed actions to the next day, proceed as follows:
1 Press the button.
The actual mode is blinking.
2 Use the and
to program.
The selected mode is blinking.
You can leave programming by pressing the
3 Press the button to confirm the selected mode.
The actual day is blinking.
4 Select the day you would like to copy to the next day by means
of the and buttons.
The selected day is blinking.
You can return to step 2 by pressing the
5 Press the and buttons simultaneously for 5 seconds.
After 5 seconds the display will show the next day (e.g. "
" " was selected first). This indicates that the day has been
copied.
You can return to step 2 by pressing the
buttons to consult the other
button once. You
and buttons
buttons to select the mode you want
button.
button.
button.
Installation and operation manual
" if
36