Nikon 35mm User Manual page 32

Step 4—Feed the computer power connector
Feed the computer power 4-pin connector, through the drive
bay from the inside as far as it will extend out through the drive
bay. Connect the cords with each 12V DC or 5V DC
connector.
Y-Adapter power connector
(Optional Y-type power connector)
Computer power connector
(Typical connector on four wire
cable)
Note: When you establish a ground, connect a grounding
cable (not provided) to the GND screw.
GND screw
Step 5—Slide the scanner part way into the drive bay
Thread the unconnected end of the 50-pin SCSI cable through
the drive bay and pull it through into the inside of the computer
while sliding the scanner rear-first into the drive bay. The
scanner should slide in easily if the rails are properly positioned.
Push the scanner in so that the rear of the scanner aligns with
the computer power connector.
Warning!
The top or bottom of the scanner should not touch anything
when sliding into the computer. Damage can occur to the
scanner or to other devices if the scanner scrapes during
installation.
- 32 -