Nikon 35mm User Manual page 44

Insertion of Film Strip
Insert the film strip into the attached film holder FH-2, and then
insert the holder into the film slot of the front panel of the unit.
Step 1
Remove the cover latch and open the upper holder. Be sure
the word Nikon, printed on the adaptor cover of the upper
holder is facing upward.
Adaptor cover
Cover latch
Upper holder
Step 2
Place the film strip on the concave section which is fixed in the
adaptor of the lower holder. Be sure to place the film strip on
the lower holder so that the emulsion surface will be facing
down (the shiny surface will be facing up). The orientation is
correct if the image edge numbers can be read.
Aperture
- 44 -
Film strip
Lower holder