Setting The Scsi Id - Nikon LS-4500AF User Manual

4.4 Setting the SCSI ID

The SCSI ID for the LS-4500AF is set at "5" when the unit is shipped. If
other SCSI devices are connected to your computer, make sure that the
SCSI ID for the LS-4500AF is different from those assigned to other SCSI
devices.
Note that in the case of a host computer which has a built-in SCSI hard
disk or built-in CD-ROM, the ID numbers of the host CPU and each SCSI
device have already been assigned.
If the IDs are the same, you must change the ID number of the other SCSI
device or the ID of the LS-4500AF to avoid any conflict.
Remarks
• To change the ID, confirm that the LS-4500AF power is off. The ID
cannot be changed when the power is on.
• As 7 has been assigned for the CPU and 0 has been assigned to the
built-in hard disk for a Macintosh, and 0 and 7 have also been assigned
to other personal computer systems, any number from 1 to 6 is recom-
mended for the ID number.
• If the same ID numbers are assigned, the system might not function, or
important data on the hard disk might be destroyed. It is therefore
essential to check the ID numbers carefully before connecting the LS-
4500AF.
Nikon
Film Scanner LS-4500AF User's Manual
4. Connecting the LS-4500AF
21