Nikon 35mm User Manual page 35

Setting the SCSI ID on the Internal Scanner
The SCSI ID is set by a set of DIP switches on the back of the
internal-mount scanner as shown below. In most cases, these
DIP switches will not be changed.
Factory default for
COOLSCAN II
- 35 -
If it is necessary to change the default SCSI ID, change the
position of the DIP switches to the proper SCSI ID. Refer to
Table 5.2 for the proper DIP switch values. When changing the
position of the switches, use a pointed instrument to toggle the
switch. Use of a pen or pencil is not recommended, since these
will leave a mark on the switch and make it difficult to
differentiate between the "on" and "off" positions.
SCSI ID DIP #1
0 Open
1 Closed
2 Open
3 Closed
4 Open
5 Closed
6 Open
7 Closed
Table 5.2 SCSI ID DIP switch values
DIP #2 DIP #3
Open Open
Open Open
Closed Open
Closed Open
Open Closed
Open Closed
Closed Closed
Closed Closed