Table of Contents
Advertisement
Operating Instructions
Introduction
Summary
2
www.PDF-Zoo.com
The instructions that follow describe how to access your security
system via a Touch-tone phone, either on or off the premises, and
describe how to perform system commands via the phone. Also
provided is a detailed explanation of the status report that will be
heard immediately following phone access to the system, and other
helpful information regarding the various operating features of this
phone system.
For your convenience, two operating overviews (accessing the system
from an on-premises phone, and from an off-premises phone) are
provided in easy-to-follow charts on pages 3 and 5. These charts are
followed by step-by-step operating instructions which provide more
detail.
If you encounter any difficulty with the operation of the phone access
system, refer to the section entitled, "If You Have Difficulty With
The Phone System" on page 27 for help.
When attempting to access the security system from a phone that is
on premises, you must enter your assigned 2-digit phone code; when
accessing the system from outside the premises, phone prompts will
ask you to enter your 2-digit phone code and your 4-digit system code.
Successful access to the security system will be possible only after
correct entry of the requested codes.
After accessing the security system via the phone, an automatic
status report on the system is provided by the phone module. During
this report, or immediately following it, you can execute virtually any
system command via the keypad on the phone, using the same key
entries normally performed at the wired keypad. Confirmation of each
successful command entry is also provided over the phone.
Advertisement
Table of Contents
