Using The Novice Voice Menu - ADEMCO 4286 VIP User Manual

Using the Novice Voice Menu

24
www.PDF-Zoo.com
If you do not enter a Touch-tone command to the system within five
seconds after the last status message was announced, it will be
assumed that help is needed, and the system will enter a "novice
mode." You will then be prompted to enter the 4-digit system code. If
there is no response to the system code request, the message will be
repeated two more times at five-second intervals. At this point, the
system will end the session by saying "GOOD-BYE, " and disconnect
from the phone line.
If the system code was entered, a phone menu of the more common
user commands, (Disarm, Arm-Away, Arm-Stay, Relay Control,
and Thermostat Control) will be provided. Again, if you do not
enter a command, the menu will be repeated two more times at five-
second intervals. At this point, the system will end the session by
saying "GOOD-BYE, " and disconnect from the phone line.
If the system code is not entered correctly, the system will not respond to the
commands. After a five-second pause, you will again be prompted to " ENTER
SYSTEM CODE NOW ." At this time, you may enter the correct system code.
If the system code was correctly entered, the system will respond with
a status message as it usually does. The "novice mode" will be re-
entered five seconds later.