Using The Relay Command Mode - ADEMCO 4286 VIP User Manual

Using the Relay Command Mode

General Information
Using the Voice Response # 70 Relay Command Mode
22
www.PDF-Zoo.com
Your system may be set up so that certain lights or other devices can be
turned on or off from a telephone keypad.
If your system has the # 7 0 Voice Response Relay Command Mode,
follow the procedure below.
For systems NOT having the # 7 0 interactive mode, refer to the User's
Manual for the system or ask your installer for specific information on the
relay command feature, if available. Systems not having the # 7 0 mode, but
equipped with relay output devices, may provide no phone feedback when a
relay command is entered via the phone.
Ask your installer if this mode is available in your system. If it is, place a
check in this box as a reminder.
To activate devices via the telephone, access the security system using your 2-
digit phone access code. When the system acknowledges the access, enter
your 4-digit system security code + [#] + 70. The following phone prompts
will begin:
Voice Prompt: "ENTER DEVICE CODE NOW"
Enter the 2-digit number of the device to be activated.
Voice Prompt: "(Voice Descriptor), DEVICE ## ON/OFF."
"For Voice Descriptor ON, ENTER 2,
for Voice Descriptor OFF, ENTER 1."
"##" represents the 2-digit device number, and (Voice Descriptor) is the
relay phone descriptor programmed by the installer for that device (for
example, HALL LIGHT).
Voice Prompt: "(Voice Descriptor) , DEVICE ## ON/OFF. TO EXIT,
ENTER 00 NOW"
Enter 00 to exit, or enter the next device number to be programmed. The
current on/off state of that device will be annunciated as described above.
Alternatively, if 6 seconds elapses with no key depression, the phone
module will annunciate the "ENTER DEVICE CODE NOW" message.