Table of Contents
Advertisement
Wiring to Power Supply
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE
PANEL
AND
LOCK
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
-
If hood is operating normally, connect three
wires (black, white and green) to house wires
and cap with wire connectors.
-
Store wires in the wiring box.
Ductwork Installation
3. Use steel pipe to connect the exhaust on the
hood to the ductwork. Use duct tape to make all
joints secure and air tight.
Duct Cover Installation
4. Mark the position of the Duct Cover-Mounting
Bracket {G}. Use reference E from Table 1 and
measurements on page 10-11.
secure Duct Cover-Mounting Bracket {G} with
two screws (provided).
NOTE: Inner duct cover will cover the Duct
Cover-Mounting Bracket.
5. Position the entire duct cover up onto the hood.
6. Secure the inner duct cover with two (3/16" x
3/8") screws {H} to the Duct Cover-Mounting
Bracket {G}. Shown in Figure 5.
7. Secure the outer duct cover with four (3/16" x
3/8") screws {H} to the Hood Mounting Bracket.
Install / Uninstall Accessories
8. Place baffle filters underneath the hood. (Figure
6)
Final Assembly
9. Turn power ON in control panel. Check all lights
and fan operation.
10. Leave
this
Installation
Operation Manual for the homeowner.
SERVICE
PANEL
Attach and
Refer to Figure 4.
Instructions
Figure 4
TO
Figure 5
Figure 6
and
6
Attach Together
Advertisement
Table of Contents
