Troubleshooting For Pyrotech Deluxe - RealFlame PYROTECH Installation & Operating Manual

TROUBLESHOOTING FOR PYROTECH STANDARD
Problem
When the remote is activated
nothing happens
The fire cuts off and won't relight The over temp snap disc has
The fan will not come on
Flame appears to be low
IF YOUR PYROTECH STANDARD FIREPLACE STILL DOES NOT OPERATE CORRECTLY CONSULT YOUR
DEALER.
ALL SERVICE AND REPAIRS SHOULD BE PERFORMED BY AN AUTHORISED AGENCY.
ALL SPARE PARTS AND OPTIONAL TRIM FINISHES ARE AVAILABLE FROM REAL FLAME PTY LTD.
30
Possible Cause
The remote is not talking to the receiver.
The remote batteries are flat.
been activated.
Possible caused by overheat
or electrical fault.
Pressure not set.
Suggested Remedy
Reprogramme the remote to
the receiver (Refer Millennium
manual in installation manual).
Replace the batteries.
Allow the fire to cool down and
then try to relight the fire. If the
fire fails to relight, contact the
manufacturer.
Contact the manufacturer.
All pressures are set in the
factory at the time of
manufacture, however the
installing plumber must make
sure the pressures are correct.
Refer to page 5.