Ventilation Requirements - RealFlame PYROTECH Installation & Operating Manual

WARNING
The Pyrotech range of fires have a primary safety glass fitted in front of the glass door. This safety glass is
fitted to this appliance to reduce the risk of injury from burns and at no time should this glass be
permanently removed.
For protection of young children or the infirm, a secondary guard is required.
INSTALLATION NOTICE
The installation of this appliance is only to be carried out by an authorised person in accordance
with the Manufacturer's Instructions, local gas fitting regulations, AS5601-2004 installation code for
gas burning appliances and any other relevant statutory regulations.
In all cases the installation of this appliance shall meet the requirements as set out in AS5601-2004.
NOTE: A slight smell may be apparent for the first few hours of use. This is due to the heat resistant
paint curing. It is recommended to open windows in the room for the first lighting of the fire. In some
instances a slight discolouration may occur inside the firebox. This is a normal condition and is not
covered by warranty.
This heater is designed to have a luminous flame and may exhibit a slight carbon deposit.
IMPORTANT SAFETY NOTICE
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIAL NEAR THE APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILST IT IS IN OPERATION.
DO NOT OPERATE WITH GLASS PANEL REMOVED FROM THIS APPLIANCE.
SERVICING
It is recommended you service your gas fire every 2 years as a minimum.

VENTILATION REQUIREMENTS

ADDITIONAL VENTILATION IS REQUIRED ONLY IF THE UNIT IS INSTALLED IN A ROOM OF LESS
THAN 10 CUBIC METRES IN SIZE - REFER AS/NZS 5601 CLAUSE 5,4,3,1.
3