Zero Clearance Model Assembly - RealFlame PYROTECH Installation & Operating Manual

PYROTECH ZERO CLEARANCE MODEL
Fit Zero Clearance Kit to unit as shown below:
ITEM 1
ITEM 3
Secure side strips (Item 1) to side brackets on fire
1.
box using screws (2 off per side strip).
Remove 2 top screws in fire box and place top
strip (Item 2) into position and secure using 2
screws.
Place base panel (Item 3) under fire box.
Place top panel (Item 7) onto assembly. Ensure
3.
all other panels sit behind folds on top panel.
Secure top panel 9 places around edge and 1
screw on the top in the centre passing through
hole in top strip as shown.
ITEM 5
ITEM 2
2.
ITEM 7
ITEM 6
Place LH side panel (Item 4) in behind lip of base
panel. Secure side panel to side strip and base
panel in 6 places.
Repeat for RH side panel (Item 5). Place rear
panel (Item 6) in behind folds on side panels and
base panel. Secure rear panel using screws
9 off.
ITEM 4
11