Table of Contents
Advertisement
AC
POWER
V O L T A G E S E L E C T I O N
Before using the Ether2DMX Router for the first time, set the voltage
selection switch on the rear panel to the setting closest to the local mains
AC voltage. The switch allows you to select between 115 and 230 volts.
P L U G I N S T A L L A T I O N
The fixture's mains lead requires a grounding-type cord cap that fits your
power distribution cable or outlet. Consult a qualified electrician if you
have any doubts about proper installation.
Warning!
For protection from dangerous electric shock, the fixture must
be grounded (earthed). The AC mains supply shall have
overload and ground-fault protection.
Following the cord cap manufacturer's instructions, connect the yellow
and green wire to ground (earth), the brown wire to live, and the blue wire
to neutral. The table below shows some pin identification schemes.
yellow/green
Wire
brown
blue
AC power
Pin
Marking
live
neutral
ground
Screw color
"L"
yellow or brass
"N"
silver
green
2
5
Advertisement
Table of Contents
