Table of Contents
Advertisement
I N P U T S
A clamping circuit on the main PCB offers limited input protection. The
inputs are pulled high internally. A switch, relay, or an open collector circuit
may be used to pull down the input.
• Maximum voltage: 75 VDC
• Minimum voltage: 0 VDC
M I D I / R S - 2 3 2
The Ether2DMX Router can send MIDI or RS-232 data over the Ethernet.
You can not use both protocols at the same time, however, because the
MIDI and RS-232 ports are electrically connected.
The Ether2DMX Router has 1 MIDI output on a female DIN-5 connector
and 1 MIDI input on a female DIN-5 connector.
RS-232 is brought out on a DB9 connector.
To configure MIDI/RS232 port
1 Use the scroll wheel to select one of the following port types:
• RS 232
• MIDI InOut
• MIDI Out
• MIDI InThru
2 Use the arrow keys to navigate through the port settings. Use the scroll
wheel to adjust the settings of the selected port type.
• Speed (RS232 only): Data rate of the port in bps.
18
DB9: Input
DB9: Ground
Basic Input Circuit
Ether2DMX Router user manual
Switch
Advertisement
Table of Contents
