Table of Contents
Advertisement
AC
POWER
A C o p e r a t i n g r a n g e
The Ethernet Switch power supply is fully auto-sensing and the device can
be connected to AC power at any voltage from 90 to 250 V at 50 or 60 Hz.
P o w e r p l u g i n s t a l l a t i o n
The Ethernet Switch is supplied with an IEC-type power cable that may
require a grounding-type (earthed) power plug suitable for your power
distribution cable or outlet. Consult a qualified electrician if you have any
doubts about proper installation.
Warning!
For protection from dangerous electric shock, the device must
be grounded (earthed). The local AC power source must be
equipped with both overload and ground-fault (earth fault)
protection devices.
Following the power plug manufacturer's instructions, connect the yellow
and green wire to ground (earth), the brown wire to live, and the blue wire
to neutral. The table below shows some pin identification schemes.
yellow/green
6
Wire
brown
blue
Ethernet Switch user manual
Pin
Marking
live
neutral
ground
Screw color
"L"
yellow or brass
"N"
silver
green
Advertisement
Table of Contents
