Table of Contents
Advertisement
To build an Ethernet bridge
1 Connect two Ether2DMX Routers directly with a CAT 5 crossover cable,
or through an ArtNet Ethernet network.
2 Give both routers a different IP address and the same subnet mask.
3 Connect up to four DMX universes to the DMX inputs on the first
Ether2DMX Router. Enable the inputs and patch each one to a unique
universe.
4 Connect up to four DMX data links to the outputs of the second
Ether2DMX Router. Enable and patch the DMX outputs as desired.
D M X R O U T I N G
Both DMX and Ethernet input can be patched to the Ether2DMX Router's
DMX outputs. This allows the router to function alone, without an Ethernet
connection, as a 4-port DMX splitter. A more likely application is to
combine the routing and bridge functions to provide DMX output at both
ends of the bridge.
Note: the Ether2DMX Router does not support DMX merge: each input
must be assigned to a unique DMX universe.
To route DMX input/ou tput
1 Connect up to 4 sources of DMX data to the DMX inputs. Enable and
assign each input port to a unique universe.
2 Connect up to 4 DMX data links to the DMX outputs. Patch the outputs as
desired.
Operation
15
Advertisement
Table of Contents
