Table of Contents
Advertisement
status: a check mark to the right of the port letter indicates data
transmission through the port.
D M X R O U T I N G
The second status screen displays the DMX universe patched to each
DMX port.
E T H E R N E T A D D R E S S
The third screen displays the unit's IP address, subnet mask, and a user-
definable ID number.
E T H E R N E T / D M X C O N V E R S I O N
In this application, the devices converts DMX to the ArtNet Ethernet
protocol and vice versa.
To convert Ethernet to DMX
1 Connect the Ether2DMX Router to the ArtNet Ethernet jack on the lighting
controller.
2 Connect the DMX data links to the DMX output jacks on the rear panel of
the Ether2DMX Router.
3 Configure the router's IP address and subnet mask.
4 Enable the DMX outputs and patch them to DMX universes as desired.
T o c on v ert D M X t o Eth e r ne t
1 Connect the Ether2DMX Router to the ArtNet Ethernet jack on the lighting
controller.
2 Connect up to four DMX universes to the DMX inputs on the rear panel of
the Ether2DMX Router.
3 Configure the router's IP address and subnet mask.
4 Enable the DMX inputs and patch each one to a unique DMX universe.
E T H E R N E T B R I D G E
Two Ether2DMX Routers can be connected to provide an Ethernet bridge
for 4 DMX universes. DMX input to the first unit is converted to Ethernet,
travels to second unit, and is converted back to DMX.
14
Ether2DMX Router user manual
Advertisement
Table of Contents
