Table of Contents
Advertisement
To restore fact ory setting s
Important! This procedure deletes all user settings.
1 Press MENU to enter setup mode.
2 Navigate to menu 17, "Clear All", with the arrow keys or scroll wheel.
Press ENTER.
3 Press both arrow keys at the same time to restore the factory default
settings, or press MENU to escape.
4 Press MENU to exit setup mode.
D M X P O R T C O N F I G U R A T I O N
The DMX ports can be enabled or disabled. When disabled, there is no
DMX signal. Enabled ports must be assigned to a DMX universe. While
each input must be patched to a unique universe, two or more outputs can
be patched to the same universe.
A B O U T P O R T N U M B E R I N G
Ports are labelled 1, 2, 3, 4 on the back panel and A, B, C, D on screen.
"IN 1" corresponds to "Input A" and so on.
A B O U T U N I V E R S E N U M B E R I N G
In normal operating mode, the Ether2DMX Router displays universe
numbers in 0-based hexadecimal. The universe numbers run from 00 to
FF. On controllers, though, universe numbers are typically displayed in 1-
based decimal format, and run from 1 to up to 256.
The default universe numbering setting displays universe numbers in 1-
based decimal in setup mode to make patching more intuitive.
There is a 0-based hex to 1-based decimal conversion table for your
convenience on page 20.
8
Ether2DMX Router user manual
Advertisement
Table of Contents
