Section 5: Replacement Parts; Section 6: A Note About Covering - Model Tech Simply Magic Instructions For Final Assembly

SECTION 5: REPLACEMENT PARTS

Global stocks a complete line of replacement parts for your Modeltech Simply Magic 40 ARF. Listed below are the
replacement parts that are available along with their respective part numbers for easy ordering convenience. We suggest
ordering directly from your local dealer. If your dealer does not stock Modeltech products, you can order directly from us at
the address shown below:
Phone: (714) 963-0329
Modeltech Simply Magic 40 (Complete) -
Instruction Manual
Wing Set
Fuselage Set
Stabilizer Set
Molded Canopy
Fiberglass Cowling

SECTION 6: A NOTE ABOUT COVERING

The covering material used on the Simply Magic 40 ARF is real iron-on, heat-shrink covering material, not cheap "shelf
paper." Because of this, it is possible with heat and humidity changes that the covering on your airplane may wrinkle
or sag. This trait is inherent in all types of heat-shrink material. To remove any wrinkles that might be visible you will
need to purchase, or borrow from a fellow modeler, a heat iron. If you need to purchase one, the Global Heat Sealing
Iron # 360900 is recommended.
Follow this simple procedure to remove the wrinkles:
Plug in and turn on the sealing iron to the medium-high temperature setting. Allow the iron to heat up for approximately
5 - 7 minutes.
After the iron has reached temperature, lightly apply the iron to the wrinkled section of the covering. Move the iron
slowly over the wrinkled section until the covering tightens and the wrinkles disappear. You will notice that the color of the
covering will darken when it is heated. When the covering cools back down, it will return to its normal color.
If the color layer smears from any of the seams the temperature of the iron is too hot. Turn the temperature dial down
and wait about 5 minutes for the iron to adjust to the lower temperature. You can remove any excess color streaks using
a paper towel soaked with a small quantity of Acetone.
WARNING
We do not suggest storing your airplane in an extremely hot environment (like the back of your car in direct
sunlight) for any length of time. The extreme heat could cause the covering material to wrinkle or sag and
possibly damage the canopy, and the fragile components of the radio system.
Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net
Global Services
18480 Bandilier Circle
Fountain Valley CA 92708
Fax: (714) 964-6236
123742
- 120050
- 120051
- 120052
- 120053
- 120054
- 120055
On the Web
http://globalservices.globalhobby.com
Hardware Set
Fuel Tank Assembly
Aluminum Landing Gear Strut
Tail Wheel Assembly
Engine Mount Assembly
Wheel Pants Set
Decal Set
- 120056
- 170807
- 120057
- 170793
- 170812
- 120049
- 120058
7