Model Tech Simply Magic Instructions For Final Assembly page 33

Step 4: Aligning & Installing the Canopy
Using a pair of scissors, carefully cut out the canopy along the molded scribe lines.
Using 220 grit sandpaper with a sanding block, carefully sand the edges of the canopy smooth and straight.
Be careful not to scratch the surface of the canopy when sanding its edges.
When satisfied with the fit, remove the canopy and carefully apply a thin bead of Pacer Formula 560 Canopy Glue
around the inside edges of the canopy.
Set the canopy back into place and realign it. Use pieces of masking tape to hold the edges of the canopy firmly in
place and remove any excess adhesive using a paper towel soaked with water.
Step 5: Installing the Servo Hatch Cover
Set the servo hatch cover into place and align it with the fuselage.
Step 6: Installing the Receiver & Battery
We don't suggest permanently installing the receiver and battery until you have balanced the airplane. Depending on
how the airplane initially balances will determine where you need to mount the receiver and battery.
Wrap the receiver and battery in foam rubber to protect them from vibration. Use masking tape or rubber bands to hold
the foam in place.
Do not wrap the foam rubber too tightly or the vibration dampening quality will be reduced.
Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net
Set the canopy onto the fuselage and align it. The canopy
should be centered over the middle of the fuselage and the
back edge of the canopy should be about 1/4" behind the
back edge of the cockpit.
Install the servo hatch cover using two M2 x 10 wood
screws - one at the front of the cover and one at the back of
the cover.
To make it easier to install the wood screws, drill 5/64"
diameter pilot holes through the hatch cover.
33