Bosch GV 630 S Repair Instructions page 4

WARNING
Comply with the following instructions:
If conducting the test in accordance with VDE 0701 via the connector,
the heater (instantaneous water heater) must be tested directly for
insulation faults due to all-pole disconnection (relays; pressure switch)
or the differential current must be measured on the appliance!
If replacing the dispensing device and the pump sump, beware of
sharp edges in the area of the stainless-steel modules.
Before commencing repairs, always disconnect the appliance from the
power supply! If tests have to be performed while the appliance is live,
always use a residual-current-operated circuit-breaker!
202_58300000104305_ara_en_b – 02.11.a
Sharp edges: Wear protective gloves.
Electrostatic sensitive devices!
Please observe handling regulations.
Seite 4 von 53