ADJ stinger ii User Instructions page 11

Stinger II
UVSP -
UV activation/speed control.
1. Press the MENU button until "UVSP" is displayed, press ENTER.
2. The display will show either "FAST" or "SLOW". Use the UP and
DOWN buttons to highlight your selection.
3. Press ENTER to confirm.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until "SLND" is displayed, press ENTER.
Either "MAST", "SL 1", or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim.
NOTe: In a Master/Slave configuration you can set one fixture to
Master and then set the next fixture to "SL 2", the fixtures will now
have contrast movement to each other.
SOUN -
Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to activate sound active mode, or
"OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SOSE -
In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until "SOSE" is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN
buttons to adjust the sound sensitivity. 0 being the least sensitive,
and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 13
System Menu Stinger II
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 10
Laser Warning Labels