ADJ stinger ii User Instructions page 9

Stinger II
DISP -
This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, press ENTER.
2. Press ENTER to "flip" the display. Press ENTER to "flip" it again.
Press ENTER when you have made your desired setup.
3. Press ENTER to confirm. To make you LED display reappear again
press any button.
FHRS
- With this function you can display the running
time of the unit.
1. Press the MENU button until "FHRS" is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU
to exit.
VER
- Use this function to display the Software version of
the unit.
1. Press the either the MENU button until "VER" is displayed, press
ENTER.
2. The display will show the software version.
RSET
- This function will reset the unit.
1. Press the MENU button until "RSET" is displayed. Press the
ENTER button and the unit will reset itself.
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 15
System Menu
REMOTE
INPUT OUTPUT
SOUND CONTROL
INPUT
POWER
DMX512
DMX+,DMX-,COMMON
1
DMX512 O T
3
3-PIN XLR
2
Stinger II
Notice:
Be sure to follow figures two and three when making your own
cables. Do not use the ground lug on the XLR connector. Do not con-
nect the cable's shield conductor to the ground lug or allow the shield
conductor to come in contact with the XLR's outer casing. Grounding
the shield could cause a short circuit and erratic behavior.
XLR Male Socket
1 Ground
2 Cold
REMOTE
INPUT
SOUND CONTROL
INPUT
3 Hot
Figure 3
Special Note: Line Termination.
used, you may need to use a terminator on the last unit to avoid erratic
behavior. A terminator is a 110-120 ohm 1/4 watt resistor which is con-
nected between pins 2 and 3 of a male XLR connector (DATA + and
DATA -). This unit is inserted in the female XLR connector of the last
unit in your daisy chain to terminate the line. Using a cable terminator
(ADJ part number Z-DMX/T) will decrease the possibilities of erratic
behavior.
COMMON
DMX +
1
DMX512 IN
3
3-PIN XLR
DMX -
2
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 8
POWER
DMX512
DMX+,DMX-,COMMON
COMMON
DMX +
1
DMX512 O T
3 3
3-PIN XLR
DMX -
2
XLR Female Socket
2 Cold
1 Ground
OUTPUT
SOUND
3 Hot
When longer runs of cable are
POWER
Termination reduces signal errors and
avoids signal transmission problems
1
and interference. It is always advisable
3
to connect a DMX terminal, (Resistance
2
120 Ohm 1/4 W) between PIN 2 (DMX-)
and PIN 3 (DMX +) of the last fixture.
Set Up
POWER
Termination
avoids sign
1 1
DMX512 IN
and interfere
3
3-PIN XLR
2 2 to connect a
120 Ohm 1/4
Figure 2
and PIN 3 (
XLR Pin Configuration
Pin 1 = Ground
REMOTE
INPUT OUTPUT
CONTROL
Pin 2 = Data Compliment (negative)
INPUT
Pin 3 = Data True (positive)
POWER
Figure 4