MASSEY FERGUSON 410 Operators Instruction Book page 95

Rear work light bulb
1. Switch off the light.
2. Remove the four screws (1,Fig. 141) and the rim
(2).
3. Ease the light unit out of the body by inserting a
finger through the hole at the base of the body and
moving the unit forward until it can be lifted out.
4. Remove the spring clip (3) from the back of the
bulb holder, then remove the bulb (4).
5. Fit a new H3 55 watt halogen bulb and reassemble
the light.
NOTE: The rear work light has a halogen bulb. Never
touch a halogen bulb lens with the fingers. Natural
moisture in the skin will cause the bulb to burn out
when the light is switched on. Always use a clean
cloth or tissue when handling halogen bulbs.
Amber warning light bulb
1. Switch off the light
2. Loosen the screws (1,Fig. 142) and remove the
lens (2).
3. Remove the failed bulb (3) from its fitting.
4. Fit a new 21 watt bulb, refit the lens and tighten
the screws.
Rear red light bulb
1. Switch off the light
2. Loosen the screws (1,Fig. 143) and remove the
lens (2).
3. Remove the failed bulb (3) from its fitting.
4. Fit a new 5 watt bulb, refit the lens and tighten the
screws.
410/420/430 - 001 8903 U1
UZEL
Maintenance and Adjustment
Fig.141
Fig.142
Fig.143
95