Attaching To The Pto Shaft - MASSEY FERGUSON 410 Operators Instruction Book

Operation
The PTO shaft, (1,Fig. 54) at the rear of the tractor
has six splines and a diameter of 35 mm (1 3/8 in)
with an annular groove for positive fixing of implement
couplings. A removable cap (2) protects the splines
and the operator when the shaft is not in use. Reinstall
the PTO shaft cover (2, Fig. 54) when not in use.
Live power take-off
The live PTO is engaged by using the dual clutch.
Depressing the clutch pedal through the first stage
disconnects the drive from the engine to the
transmission without interrupting the operation of the
PTO.
To engage live PTO:
Depress the clutch pedal fully, move the engagement
lever to the rear 'A'. Set the engine speed to 1685
rpm for 540 PTO shaft speed.
To disengage live PTO:
Depress the clutch pedal fully, move the engagement
lever forward to the vertical position 'B'.
Independent power take-off (IPTO)
The Independent Power Take-off (IPTO) (Fig. 55)
allows the operator to engage and disengage the
PTO without using the engine clutch and independent
of the transmission. When operating the engagement
lever, DO NOT engage at engine speeds over 1600
rpm. Ensure that the IPTO clutch is either fully
engaged, or fully disengaged. Partial engagement,
or slow engagement can cause damage to the internal
components.
To engage IPTO:
Move the engagement lever back to position 'A'. Set
the engine speed to 1789 rpm for 540 rpm PTO shaft
speed.
To disengage the IPTO:
Move the lever forward to the vertical position 'B'.

Attaching to the PTO shaft

1. Unscrew and remove the PTO cap and store it in
the tool box for future use.
2. Attach the PTO shaft to the splined shaft on the
tractor. Ensure that the locking device has securely
retained the shaft.
3. Ensure that all the guards are in place. A slot (1)
is provided in the top of the PTO guard to enable the
driveline shield to be bolted to the tractor when
pulltype PTO driven equipment is being used. A
hole (2) is also provided for the PTO driveline shield
chain.
4. If PTO driven equipment is connected to the
swinging drawbar, the drawbar must be set so that
the horizontal distance 'A' between the end of the
PTO shaft and the pin hole in the end of the drawbar
is 356 mm, (14 in) if using the six spline
540 rev/min shaft.
44
Fig. 54
Fig. 55
Fig. 56
1
2
410/420/430 - 001 8903 U1
UZEL