MASSEY FERGUSON 410 Operators Instruction Book page 29

10. Main gear lever
The gear lever knob has a diagram engraved on its
top face to indicate the respective gear positions. On
synchromesh gearboxes changes can be made on
the move in the top two gears. The gear lever is used
in conjunction with the range lever to select the
required speed - also refer to the travel speed chart,
and Operation section.
(Fig. 32) gives details of the gear shift patterns for
the types of gearboxes that can be fitted as follows:
1. E i g h t - s p e e d s y n c r o m e s h g e a r b o x
2. Eight-speed shuttle gearbox
11. Eight Speed Shuttle Forward/Reverse Lever
This lever (Fig.32A) is used on eight speed shuttle
transmission to select the forward, neutral and reverse
gears. (MF420/430)
Lift the lever "UP" to engage either forward or reverse
gear. For details of operation, (see page 41).
IMPORTANT: The tractor MUST be stationary when
shifting from forward to reverse or vice versa,
otherwise serious damage could be caused to the
transmission.
12. Four-wheel Drive Control Lever (if fitted)
This lever engages the four-wheel drive when pushed
"DOWN". For details - (see page 41)
13. Control valve lever(s)
These levers control auxiliary hydraulic equipment
(Fig. 33). For details of operation - (see page 48).
410/420/430 - 001 8903 U1
UZEL
Controls and Instruments
Fig. 32
Fig. 32A
Fig. 33
29