MASSEY FERGUSON 410 Operators Instruction Book page 78

Maintenance and Adjustment
Front track adjustment (two-wheel drive)
NOTE: The maximum track position is for light work
only. Do not use when operating a front end loader.
The front wheel track is adjustable (See Fig.115).
Adjustment is as follows:
1. Raise the front wheels clear of the ground.
2. Remove the bolts and nuts (1, Fig.114) each side.
3. Remove the tie rod bolts (2) each side.
4. Slide the axle arms and the tie rods to the required
track setting.
5. Refit the six bolts and nuts (1) through the
appropriate axle beam holes and the tie rod bolts (2)
similarly.
6. Tighten the axle beam nuts to a torque of 200 Nm
(148 lbf-ft).
7. Tighten the tie rod bolts to a torque of 85 Nm (63
lbf-ft)
8. Check the front wheel alignment, see page (76-
77)
78
Fig.114
WITH
6.00X16
WHEEL
1227
(48 in)
1328
(52 in)
1430
(56 in)
1532
(60 in)
Fig.115
WITH
8LBX15- 15
WHEEL
1384
(54 in)
1485
(58 in)
1586
(62 in)
1687
(66 in)
410/420/430 - 001 8903 U1
UZEL