Nikon MB-D10 User Manual page 23

The MB-D10 can be used with one EN-EL3e, EN-EL4a, or EN-EL4 rechargeable Li-ion battery, or with eight AA batteries. A BL-3 battery-chamber
cover (available separately) is required when using an EN-EL4a or EN-EL4 battery.
Before inserting batteries, be sure that the camera is off and that the MB-D10 control lock is in the position.
Turn the MB-D10 battery-chamber latch to
Ready the batteries as described below.
: Matching the indentations on the battery to the projections on the MS-D10EN holder, insert the battery with the arrow (▲) on the bat-
tery toward the battery holder power terminals (Figure F- ). Press the battery lightly downward and slide it in the direction of the arrow until
the power terminals click into place (Figure F- ).
: If the battery release on the optional BL-3 battery-chamber cover is positioned so that the arrow ( ) is visible, slide the battery
release to cover the arrow (Figure G- ). Insert the two projections on the battery into the matching slots on the BL-3 (Figure G- ) and slide the
BL-3 battery lock release to reveal the arrow.
: Place eight AA batteries in the MS-D10 battery holder as shown in Figure H, making sure that the batteries are in the correct orientation.
Insert the battery or battery holder in the MB-D10 and latch the battery-chamber cover (Figure I). Make sure the battery or holder is fully inserted
before turning the latch.
Turn the camera on and check the battery level in the control panel or viewfi nder. If the camera does not turn on, check that the battery is cor-
rectly inserted.
and remove the battery holder (Figure E).
En
7