Door Alignment; Fan And Fan Motor (Evaporator) - Kenmore 795. 72063.11 series Service Manual

3-3 Door Alignment

If the level of refrigerator doors is uneven, follow the
instructions below to align the doors:
Turn the leveling legs (CCW) to raise or (CW) to lower the
height of the front of the refrigerator by using flat blade
screw driver or 11/32" wrench. Use the wrench (Included
with the User Manual) to adjust the bolt in the door hinge to
adjust the height. (CW to raise or CCW to lower the height.)
The Left refrigerator door has an adjustable nut, located on
the bottom hinge, to raise and lower them to align properly.
If the space between your doors is uneven, follow the
instructions below to align the Left door evenly: Use the
wrench (included with the Use & Care Guide) to turn the nut
in the door hinge to adjust the height To the right to raise or
to the left to lower the height.
On the other hand, The Right refrigerator door does not
have an adjustable nut. If the space between your doors is
uneven, follow the instructions below to align the Right
door:
1. With one hand, lift up the Right door you want to raise at
middle hinge.
2. With other hand, use pliers to insert snap ring as shown.
3. Insert additional snap rings until the Right door is aligned.
(Three snap rings are provided with unit.)
Down
Up
3-4 FAN AND FAN MOTOR
3-4-1 FAN AND FAN MOTOR(Freezer Room)
1. Remove the freezer drawer.
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille assembly by removing four screws
and pulling the grille assembly forward.
4. Remove the Fan Motor assembly by loosening 3 screws
and disassembling the shroud.
5. Pull out the fan and separate the Fan Motor and Bracket
Motor.
FAN MOTOR
BRACKET
MOTOR
Ice Fan Assembly
* Ice Fan Assembly Replacement
1) Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
2) Pull out the cover sensor to disassemble by using tools
shown in the figure.
3) Pull out the cover grille to disassemble by using tools
shown in the figure.
4) Put your hand into the inside of grille to disassemble
shown in the figure.
5) Disconnect wire harness of the grille assembly.
6) Remove the Ice fan assembly by loosening all screws.
(1)
(4)
3-4-2 FAN AND FAN MOTOR(Refrigerator Room)
1. Remove all shelf and guide rail on left side.
2. Remove upper and lower Caps by using a flat
screwdriver. And then, remove 2 screws under Caps.
3. Pull out the Multi Duct outward slightly.
4. Disconnect the lead wire on bottom as shown.
5. Grip both side of Multi Duct, pull it out.
6. Remove the Shroud Refrigerator by loosening 4 screws
and disassembling the Multi Duct.
7. Pull out the Fan Motor
- 8 -
Shroud
(3)
(2)
(5) (6)