Kenmore 795. 72063.11 series Service Manual page 84

14. DESCRIPTION OF FUNCTION & CIRCUIT OF MICOM
14-1 FUNCTION
14-1-1 Function
When the appliance is plugged in, default set values are 37°F for Refrigerator and 0°F for freezer.
You can adjust Refrigerator and Freezer control temperature by pressing ADJUST button on display
1. When the power is initially applied or restored after a power failure, it is set to Control temperature Previously.
2. If you do not press any button after turning on the power, only the water, Ice type, lock Icon that has been selected will
be turned on and all other LEDs on the Dispenser Panel will be turned off Within 60 seconds. (Power Save Mode)
3. If you press a button, only the water, Ice type, lock Icon that has been selected will be turned on and all other LEDs on
the Dispenser Panel will be turned off Within 20 seconds. (Power Save Mode)
14-1-2 How to Toggle the Display between °F & °C
1. The initial setting is °F and the display temperature mode can be converted °F to °C or °C to °F by pressing and holding
Freezer Temperature Button and Refrigerator Temperature Button at the same time for over 5 seconds.
14-1-3 Alarm/Lock function (dispenser and display button lock)
1. When refrigerator is firstly turned on, the buttons are not locked.
"LOCK" is deactivated with light off.
2. To lock the display, the dispenser, and the control panel, press
and hold the LOCK button for 3 seconds. "LOCK" is activated with light
on.
3. The LOCK button is the only control feature that remains active
in the locked state. The buzzer sound, other control buttons,
and the dispenser are deactivated.
4. To release from the locked state, press and hold the LOCK
button again for 3 seconds.
5. If you don' t hold the Alarm/Lock button more than 3 seconds,
Alarm function will be changed and alarm for opened door will be on/off
same as alarm icon indicating.
14-1-4 Water Filter condition display function
1. There is a replacement indicator light for the water filter
cartridge.
2. Water filter needs replacement every six months for
using water filter.
3. When the Water Filter Icon lights on, you must
exchange the filter.
4. After replacing the filter, press and hold the water filter
reset button for 3 seconds .
After then water Filter icon turn off with reset status
Ex) In selecting
"LOCK"
In initial Power On
Classification
/ Filter RESET
Filter Status
Display
- 84 -
Ex) In selecting
"LOCK" again
On