Removal Of Elements (Electric Models); Removal Of Front Foot Bracket Assembly - Fisher & Paykel DEGX1 Service Manual

(j) Unscrew the gas pipe from the gas regulator valve.
Reassembly
(a) Refit in reverse manner. Ensure that the regulator/valve is screwed onto the gas pipe to the
correct angle so that the gas burner bracket sits flat on the base panel when assembled. Ensure
that the gas pipe bracket tabs go through the slots in the back of the base panel.
7.41

Removal of Elements (Electric Models)

(a) Follow instructions for removal of the drum and chassis assembly. (Refer to Section 7.16)
(b) Remove the push on connectors from the thermostat attached
to the top combustion housing.
(c) Remove the screw securing the top element housing to the
bottom element housing.
(d) Lift the top housing clear.
(e) Remove the push on connectors from the element.
(f) Lift the element clear.
Reassembly
(a) Refit in reverse manner.
7.42

Removal of Front Foot Bracket Assembly

(a) Follow instructions for removal of the drum and chassis
assembly. (Refer to Section 7.16)
(b) Lay the cabinet on its side on a protective surface, with
the foot bracket to be removed uppermost.
(c) With a screwdriver, push inwards on the rear tab of the
foot bracket.
(d) When this tab is clear of the base panel, slide it towards
the rear about ¾" (18mm).
(e) The foot bracket assembly can now be hinged outwards
and removed from the cabinet.
Reassembly
(a) Refit in reverse manner.
53