Yamaha 2012 Grizzly 300 Service Manual page 227

FRONT AND REAR WHEELS
1
2
New
1
2
2
INSTALLING THE FRONT WHEEL HUB
BEARINGS
1. Install:
• bearings
1
TIP
Face the oil seal side of the bearing inward.
INSTALLING THE WHEEL HUBS
The following procedure applies to both of the
front and rear wheel hubs.
1. Install:
1
• axle nut
Front wheel hub:
80 Nm (8.0 m
Rear wheel hub:
135 Nm (13.5 m
2
• cotter pin
New
TIP
• Do not loosen the axle nut after torquing it. If
the axle nut groove is not aligned with the cot-
ter pin hole, align the groove with the hole by
tightening the axle nut.
• Bend the longer cotter pin up.
INSTALLING THE WHEELS
1. Install:
• wheels
TIP
The arrow mark
direction of rotation
2. Tighten:
• nuts
2
Front wheel nuts:
45 Nm (4.5 m
Rear wheel nuts:
55 Nm (5.5 m
WARNING
Tapered wheel nuts
the front and rear wheels. Install each nut
with its tapered side towards the wheel.
8-8
CHAS
kg, 57.9 ft lb)
• •
kg, 97.6 ft lb)
• •
on the must point in the
1
of the wheel.
kg, 32.5 ft Ib)
• •
kg, 40.0 ft Ib)
• •
are used for both
2