Baumatic BHC609 Instruction Manual page 20

o The cable connections must be in accordance with the diagram
located on the bottom of the hob (see above). The links must
also be positioned as indicated.
o You should use a good quality screwdriver to carefully, fully
tighten ALL of the terminal screws.
o If when the hob is first switched on, only two of the zones
work, you should recheck that the terminal screws are all
fully tightened and the links are in position. This should
be done before contacting the Customer Care Department.
o IMPORTANT: The appliance must NOT be connected to the
mains supply by means of a 13A plug and socket.
o The cable can be looped if necessary, but make sure that is not
kinked or trapped when the hob is in position. Care must be
taken to avoid the cable being in contact with hot parts of the
appliance.
20