Baumatic BHC609 Instruction Manual page 18

o IMPORTANT: There are ventilation holes around
the outside of the hob. YOU MUST ensure that
these holes are not blocked by the work top,
when you put th
drawing opposite).
o NOTE: Your appliance comes fitted with a sealing
strip already attached to the underside of the hob.
This should not be removed as it will prevent liquid or
spillages from penetrating the underneath of the hob.
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be
serviced.
Carefully lower it into the aperture hole that you have cut out.
o
(A) Clamp
(B) Screw
( C) Sealing strip
o Place the clamp (A) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw (B) through the clamp (A) so that
the clamp is attac
the position of it.
o On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. T
(B) to secure the hob into position.
e hob into position (see
hed to the hob, but so that you can still adjust
hen fully tighten the screws
18