Step 3 - Automatic Line Feed System; Step 4 - To Manually Feed The Line; Stopping - Qualcast GGT350A1 Assembly Manual

F
Operating the Grass Trimmer
Step 3 – Automatic line feed system
When initially switching on the trimmer, a small length of line is fed out.
A 'clattering' noise will be heard when the lines hit the line cutter. DO NOT BE ALARMED this is quit
normal. After about 5 seconds the line will be cut to the correct length and the noise will reduce as the
G
motor receives full speed. If the noise of the line being cut can't be heard, more line will be fed out.
To feed more line, it is first necessary to allow the trimmer to stop completely, then restart, allowing the
motor to reach full speed. Repeat above 4 until you hear the lines hitting against the line cutter. (Do not
repeat this procedure more than 6 times)
Step 4 – To Manually Feed The Line
H
A
If required, line can be fed out manually.
I
B
To operate, press and release manual line feed button (A), whilst gently pull out the lines until the
lines reach the line cutter.
When the required amount of line is fed out, gently pull on the second line (there is no need to
press the manual line feed button again)
If the line extends past the line cutter, too much line has been fed out.
If too much line is fed out, remove the spool cap and click spool anti-clockwise until the line is at the
desired length.

Stopping

J
Stopping
Release the switch to stop
A
Customer Helpline 0344 801 0979
ORIGINAL INSTRUCTIONS
15