Power Tool Use And Care; Service; Additional Safety Rules For Line Trimmers - Qualcast CLGT1825D Instruction Manual

Safety Information
Important - Please read these instructions fully before starting assembly

Power Tool Use and Care

•
Do not use the power tool for applications that are beyond it's capacity. Use the correct power tool for
your application. The correct power tool will do the job better and more safely at the rate for which it
was designed.
•
Do not use the power tool if the switch does not turn it ON and OFF. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
•
Disconnect the battery from the power source before making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures reduce the risk of starting the power tool
accidentally.
•
Store the tool out of the reach of children. Do not allow people unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
•
Always maintain the power tool in good working order. Check for misalignment or binding of moving
parts, breakage of parts, or other conditions that would affect it's operation. If damaged, have the
power tool repaired before use. Many accidents are caused by poorly maintained power tools.
•
Keep cutting tools sharp and clean. Properly maintained cutting attachments with sharp cutting
edges are less likely to bind and are easier to control.
•
Only use the tool, accessories, and attachments as described in these instructions. Using the tool for
operations it is not intended for could cause damage to the tool and hazardous situations. Always
consider the working conditions and the work to be performed.

Service

• Have the power tool serviced by a qualified repair personnel using only manufacturer's recommended
replacement parts. This will ensure that the safety of the power tool is maintained.

Additional Safety Rules for Line Trimmers

• Always wear adequate protective clothing when operating the tool to avoid injuries to face, eyes,
hands, feet, head or hearing. Use safety glasses or a face shield, high boots or sturdy shoes, long
trousers, work gloves, a hard hat and hearing protection.
• When starting up and when the tool is in operation, keep the cutting section away from all parts of
the body, especially the hands and feet.
• Do not start the tool when it is upside down or when it is not in the operating position.
• Switch the motor off and remove battery when the tool is not being used, left unattended, being
cleaned, being moved from one place to another or when the spool is being changed or the length of
line manually adjusted.
• Do not operate the tool near people, especially children or pets. Turn it off if they get too close.
Maintain a safe distance of at least 5m from other people when using the tool.
• Keep a balanced and stable stance while using the tool.
Customer Helpline 0845 077 8888
5