Makita 2414db Instruction Manual page 7

Stopper plate
The stopper plate prevents the wheel from
contacting the workbench or floor surface.
When a new wheel
is
installed, set the
stopper plate to the position
(A).
When the
wheel wears down to below 330 mm (1 3")
in diameter, set the stopper plate to the
position (B) to allow an increased cutting
capacity with the worn down wheel.
I I
Interval between vise and guide plate
The original spacing or interval between the vise and the guide plate is 0 - 170 mm (0 -
6-1 1/16"). If your work requires wider spacing or interval, proceed as follows to change
the spacing or interval.
Remove the two hex bolts which secure the guide plate. Move the guide plate as shown
in the figure and secure
it
using the hex bolts. The following interval settings are possible:
35 - 205 mm (1-3/8" - 8-1/16")
70 - 240 m m (2-3/4"
-
9-7/16")
Socket wrench
Hex bolts
2
-
Guide plate
0
\
\ ' .
' I
' 7
CAUTION:
Remember that narrow workpieces may not be secured safely when using the two, wider
interval settings.
7