Technical Data; Troubleshooting - Philco PL 1061-5 TL User Manual

Do this procedure also when
you want to do the emergency
drain.
1. Close the water tap and disconnect the
water inlet hose.
2. Disconnect the drain hose from a sink
or spigot.
3. Put the ends of the drain and inlet hose
in a container. Let the water flow out of
the hoses.
4. Set the Drain programme and let it
operate until the end of the cycle.

TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
1)
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
Introduction
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
5. Turn the programme knob to Stop to
6. Disconnect the appliance.
Make sure that the temperature is more
than 0 °C before you use the appliance
again. The manufacturer is not responsible
for damages caused by low temperatures.
Width/ Height/ Depth/ To-
tal depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
The red indicator of button
disconnect the appliance from the
power supply.
WARNING!
400 mm/ 890 mm/ 600 mm/ 600 mm
230 V
2300 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
6 kg
A+
1000 rpm
WARNING! Deactivate the
appliance before you do the
checks.
33
flashes.